konus – Übersetzung – Keybot-Wörterbuch

Spacer TTN Translation Network TTN TTN Login Français English Spacer Help
Ausgangssprachen Zielsprachen
Keybot 4 Ergebnisse  reprap.org
  RepRapPro Mendel hot en...  
Setzen Sie den Isolationskonus auf die Düse. Die Düse sollte etwas weiter aus dem Block herausragen als der Konus tief ist. Der Konus wird später auf die Düse geschraubt und die Düse muß ein klein wenig aus dem Konus herausschauen.
Screwing the tube in will have reduced its internal diameter slightly. Gently twist a 2mm drill by hand in the end of the brass to thin the tube where it is inside the screw thread. If you have a small hand-chuck this is made easier:
  RepRapPro Mendel hot en...  
Setzen Sie den Isolationskonus auf die Düse. Die Düse sollte etwas weiter aus dem Block herausragen als der Konus tief ist. Der Konus wird später auf die Düse geschraubt und die Düse muß ein klein wenig aus dem Konus herausschauen.
Screwing the tube in will have reduced its internal diameter slightly. Gently twist a 2mm drill by hand in the end of the brass to thin the tube where it is inside the screw thread. If you have a small hand-chuck this is made easier:
  RepRapPro Mendel mainte...  
Schrauben Sie den Teflon Konus außen an der Düse ab und legen diesen beiseite. Geben Sie bei den nächsten drei Schritten acht, daß Sie die Verdrahtung nicht zerstören, während Sie Dinge auseinanderschrauben.
Unscrew the PTFE cone at the bottom of the nozzle, and set that aside. For the next three steps, take care not to damage the wiring as you unscrew things. Take your time and hold the wires out of the way.
  RepRapPro Mendel hot en...  
Setzen Sie den Isolationskonus auf die Düse. Die Düse sollte etwas weiter aus dem Block herausragen als der Konus tief ist. Der Konus wird später auf die Düse geschraubt und die Düse muß ein klein wenig aus dem Konus herausschauen.
Screwing the tube in will have reduced its internal diameter slightly. Gently twist a 2mm drill by hand in the end of the brass to thin the tube where it is inside the screw thread. If you have a small hand-chuck this is made easier: