|
Tratándose de chapas, placas de plástico y materiales básicos para placas de circuitos impresos, el dbk+5 tiene que montarse con una inclinación de 10° a 18° respecto a la hoja pasante. El ángulo óptimo tiene que averiguarse mediante ensayos. Los cartones ondulados se miden bajo un ángulo de 35° a 45° en posición inclinada contra las ondulaciones.
|
|
Papers require the sensors to be mounted perpendicular to the passing sheets. But in the case of sheet metal, plastic sheets and boards for printed circuits, it is preferable to mount the dbk+5 at an angle of 10–18° to the passing sheets. The optimum angle should be determined by way of trials. Corrugated cards should be scanned at an angle of 35–45° to the corrugations.
|
|
Initialement les capteurs sont montés perpendiculairement au passage des supports. Mais dans le cas de tôles, de feuilles en plastiques et de planches pour circuits imprimés, il est préférable de monter le dbk+5 avec un angle de 10-18° par rapport aux supports. L'angle optimal doit être déterminé aux moyens d'essais. Les cartons ondulées doivent être scannées avec un angle de 35 à 45 ° par rapport aux ondulations.
|
|
Papiere können senkrecht zum durchlaufenden Bogen abgetastet werden. Bei Blechen, Kunststoffplatten und Leiterplatten-Basismaterialien ist die dbk+5 mit einer Neigung von 10°–18° zum durchlaufenden Bogen zu montieren. Der optimale Winkel ist durch Versuche zu ermitteln. Wellpappen sind unter einem Winkel von 35°–45° schräg gegen die Wellen zu vermessen.
|
|
Per quanto concerne la carta è necessario che i sensori siano montati in posizione verticale rispetto ai fogli che scorrono. Ma nel caso di lamiere, lamine in materia plastica e materiali di base per circuiti stampati il dbk+5 deve essere montato con una inclinazione di 10° - 18° rispetto allo scorrimento dei fogli. L'angolo ottimale deve essere individuato attraverso l'effettuazione di tentativi. I cartoni ondulati devono essere misurati con un angolo di 35° - 45° contro le ondulazioni.
|
|
Bij papier moet de sensor loodrecht t.o.v. de doorlopende laag gemonteerd worden. Bij plaatwerk, kunststof platen en basismaterialen voor printplaten moet de dbk+5 onder een hoek van 10° – 18° t.o.v. de doorlopende laag gemonteerd worden. De optimale hoek moet proefondervindelijk worden bepaald. Golfkarton moet onder een hoek van 35° – 45° en schuin ten opzichte van de golven worden gemeten.
|
|
Papers require the sensors to be mounted perpendicular to the passing sheets. But in the case of sheet metal, plastic sheets and boards for printed circuits it is preferable to mount the dbk+5 at an angle of 10-18° to the passing sheets. The optimum angle should be determined by way of trials. Corrugated card should be scanned at an angle of 35-45° to the corrugations.
|
|
По документации, материал должен проходить перпендикулярно поверхности датчика. Но в случае листового металла, пластиковых листов и печатных плат, предпочтительнее установить dbk+5 под углом 10-18 ° к движению листов. Оптимальный угол определяется опытным путем. Гофрированный картон определяется под углом 35-45 ° к рифленой поверхности.
|