|
|
Mit dieser Pumpe kann zwischen Nieder- und Hochdruck und entsprechend zwischen einem Druckverhältnis von eins zu eins oder zwei zu eins umgestellt werden, abhängig von der Leistung der Filterpressanlage.
|
|
|
Pour résoudre le problème, le distributeur local HSC Pumps a suggéré d'essayer la pompe Husky 1050HP de Graco, qui permet d'alterner facilement basse pression et haute pression et qui offre un rapport de dosage de 1:1 ou 2:1 selon les performances du filtre-presse. Dans la plupart des cas, la pompe est réglée sur un rapport de dosage de 2:1, avec une pression de service de 4,5 bars. Elle peut donc fournir la pression requise par l'installation. Après un essai complet de la pompe Husky 1050HP dans l'installation du filtre-presse, Forbo Flooring a constaté que le système de filtre-presse fonctionnait parfaitement et a été très satisfait du résultat. La pompe a été commandée : en permettant un fonctionnement optimal et en offrant plus de fiabilité, elle s'est révélée être la solution la plus adaptée à l'installation.
|
|
|
Como solución, el distribuidor local, HSC Pumps, sugirió probar la bomba Husky 1050HP de Graco. Esta bomba permite cambiar entre baja presión y alta presión, lo que proporciona una relación de mezcla 1:1 o 2:1, dependiendo del rendimiento de la instalación de filtro prensa. En la mayoría de los casos, la bomba se ajusta a una relación de mezcla 2:1 con una presión de funcionamiento de 4,5 bares y, por lo tanto, puede suministrar la presión que necesita la instalación. Tras una exhaustiva prueba de la Husky 1050HP en la instalación del filtro prensa, en Forbo Flooring observaron que el sistema de filtro prensa funcionaba muy bien y quedaron muy satisfechos con el resultado. La bomba fue adquirida y resultó ser la opción más adecuada para la instalación, ya que proporciona un funcionamiento óptimo y una mayor fiabilidad.
|
|
|
Come soluzione, il distributore locale HSC Pumps ha suggerito di provare una pompa Graco Husky 1050HP. Questa unità consente di passare da una posizione di alta a una di bassa pressione con un rapporto di 1:1 o 2:1, in funzione delle prestazioni dell'impianto della filtropressa. Nella maggior parte dei casi, la pompa è impostata sul rapporto 2:1 con una pressione d'esercizio di 4,5 bar e può pertanto fornire la pressione necessaria all'impianto. Dopo un attento test dell'unità Husky 1050HP installata, Forbo Flooring ha riscontrato un ottimo funzionamento del sistema e ha mostrato di essere soddisfatta dei risultati. La pompa è stata quindi ordinata e si è rivelata perfetta per l'impianto, assicurando all'azienda un funzionamento ottimale e una maggiore affidabilità.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
Als oplossing stelde de plaatselijke distributeur, HSC Pumps, voor om de Husky 1050HP-pomp van Graco te testen. Met deze pomp kan worden geschakeld tussen een lage- en een hogedrukstand, voor een verhouding van 1:1 of 2:1, naargelang van de prestaties van de persfilterinstallatie. In de meeste gevallen wordt de pomp ingesteld op een verhouding van 2:1, met een werkdruk van 4,5 bar. Zo kan zij de nodige druk leveren om de installatie te laten werken. Na een uitvoerige test van de Husky 1050HP in de persfilterinstallatie, merkte Forbo Flooring dat het persfiltersysteem bijzonder goed werkte en waren zij erg tevreden met het resultaat. De pomp werd meteen besteld, aangezien ze het best geschikt bleek voor de installatie en een optimale werking en grotere betrouwbaarheid bood.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
|
|
As a solution, the local distributor, HSC Pumps, suggested to test a Graco Husky 1050HP pump. This pump enables to switch between a low and high pressure position which provides a 1:1 or 2:1 ratio depending on the performance of the filter press installation. In most cases, the pump is set at a 2:1 ratio with a working pressure of 4.5 bar and can thereby supply the required pressure needed by the installation. After a thorough test of the Husky 1050HP in the filter press installation, Forbo Flooring noted that the filter press system worked very well and was very satisfied with the result. The pump was ordered as it turned out to be best suited for the installation, providing optimal operation and improved reliability.
|
